top of page
HVAC Design
Practical HVAC design guidance, calculations, and engineering workflows.


Pump Minimum-Flow Recirculation: Estimate Heating in a Short Bypass Loop
A bypass can maintain pump flow while repeatedly heating the same small water volume. Trace where shaft power ends up before assuming circulation removes heat.
Oct 184 min read


Condenser Air Recirculation: Calculate Entering Air Above Outdoor Ambient
The weather temperature may be lower than the air entering an outdoor condenser. A simple recycle balance explains the difference and helps frame the right field checks.
Oct 185 min read


AHU Filter Bank Sizing: Check Module Count, Actual Dimensions and Rated Flow
A bank can fit the AHU drawing and still be short of its selected airflow duty. Reconcile module count, physical dimensions and each filter model’s performance.
Oct 185 min read


Occupied-Room CO₂: Check the Assumptions Before Inferring Outdoor Airflow
A measured CO₂ value becomes an airflow estimate only through a model. Test the occupancy, outdoor background, sensor difference and steady-state assumptions before relying on it.
Oct 185 min read


Steam Humidifier Absorption Distance: Reserve the Clear Duct Run
A humidifier can meet the moisture load and still fail the duct-layout review. Match the selected dispersion assembly to the clear run and each operating condition.
Oct 174 min read


Sensible Heat Recovery: Reconcile Unequal Air-Stream Heat-Capacity Rates
A 75% exchanger effectiveness need not produce a 75% supply-air temperature change. Reconcile both air-stream heat balances before reducing the downstream coil duty.
Oct 174 min read


Hydronic Heat Rate: Match Water Density to the Flow-Meter Location
The same water stream can have different supply and return volume flows. A worked heat-rate calculation shows why density belongs at the flow-meter location.
Oct 174 min read


Humidity-Sensor Temperature Mismatch: Check Dew Point Before Adjusting RH
A 2°C sensing-temperature difference can explain a 6.7-percentage-point RH disagreement. Reconstruct vapor pressure and dew point before deciding the sensor has drifted.
Oct 175 min read


Pipe Thermal Movement: Separate Installation Displacement from Full Temperature Travel
A pipe installed at 30°C can contract in service and expand during shutdown. Calculate both signed movements before reporting the full temperature travel.
Oct 175 min read


Series Air Filters: Multiply Penetration for Each Particle Size
A 40% stage followed by an 80% stage gives 88% removal at the stated particle size. Follow the particles that remain before comparing a filter train.
Oct 174 min read


Pump Motor Selection: Check Absorbed Power Across the Allowed Flow Range
A motor that covers the scheduled pump duty may be inadequate at another permitted flow. Compare shaft power, operating limits and site-rated motor output together.
Oct 165 min read


Hydronic Flushing Flow: Check Every Pipe Section Before Choosing a Temporary Pump
Branch flushing targets can leave the common main below its required velocity. An original section-by-section example connects flow verification to temporary-pump duty.
Oct 165 min read
bottom of page