top of page
HVAC Design
Practical HVAC design guidance, calculations, and engineering workflows.


AHU Heat-Recovery Bypass: Compare Avoided Cooling Power with Added Fan Power
A recovery core can reduce cooling load while increasing total input power. Find the operating crossover using incremental pressure loss, fan heat and marginal plant efficiency.
Oct 215 min read


High-Altitude AHU Cooling Coils: Rebuild the Dry-Air Mass and Moisture Balance
Altitude changes more than air density. Rebuild both psychrometric states before checking an AHU cooling coil, moisture removal and the airflow stated on the schedule.
Oct 215 min read


Cooling-Coil Face-and-Bypass Mixing: Meet Humidity as Well as Temperature
A bypass damper can produce the right dry-bulb temperature while blending too much moisture back into the supply. Solve both limits before accepting the sequence.
Oct 204 min read


VAV Reheat Capacity: Separate Coil Output from Heat Delivered to the Room
An 8 kW reheat coil does not necessarily provide 8 kW of room heating. First account for warming the cold primary air, then check the discharge-temperature ceiling.
Oct 205 min read


Duct Surface Condensation: Check Surface Temperature and the Outside Film
The same insulation can have a different condensation margin when the outer-surface heat-transfer conditions change. Calculate the temperature at the actual exposed face.
Oct 195 min read


Radiant Heat Gain vs Cooling Load: Carry Earlier Hours into the Calculation
A load can remain after its heat source switches off. An explicitly hypothetical response calculation shows how to retain earlier gains without double counting energy.
Oct 195 min read


Glycol Refill Calculations: Include the Diluted Fluid Left in the System
Adding a target-strength premix cannot correct a weaker solution already in the system. Account for retained fluid before calculating the refill batch.
Oct 195 min read


Supply-Air Temperature Reset: Find the Zone That Sets the Warmest Allowable Air
A mild outdoor day does not mean every room can accept warmer supply air. Calculate each zone’s limit, then verify humidity, airflow and the actual delivery temperature.
Oct 195 min read


Fan-Inlet Airflow Measurement: Check K-Factor Units and Density Compensation
A fan’s inlet pressure signal is not airflow until the correct conversion is applied. Keep the nozzle factor, installation and density compensation together.
Oct 195 min read


Reverse-Return Hydronic Piping: Check Header Losses Before Assuming Equal Flow
A reverse-return layout can have equal pipe lengths yet unequal circuit flow. The missing input is the changing flow carried by each header section.
Oct 195 min read


DOAS Supply Humidity: Solve Each Zone’s Moisture Balance Before Selecting Dew Point
A central moisture total can pass while one room stays humid. Find the limiting moisture load per unit of delivered dry air before choosing the DOAS discharge condition.
Oct 195 min read


TAB Readings Near Tolerance: Agree the Measurement Decision Rule
A reading can fall inside its airflow tolerance while its uncertainty interval crosses the limit. Agree how acceptance will be decided before the final TAB report.
Oct 185 min read
bottom of page